The revision of EU GMP Annex 1 has reshaped how sterile manufacturers think about fluid path design. Rattiinox raises a point that resonates strongly with our clients across the Turkish and regional pharmaceutical sector: the question is no longer simply whether a system can perform PUPSIT (Pre-Use Post-Sterilisation Integrity Testing), but whether it was designed from the outset to do so cleanly.
Assembly versus integration
Many existing installations achieve PUPSIT by adding valves, tees and connectors onto an existing line. Every added junction, however, introduces dead-legs, additional wetted surfaces and cleaning challenges. Under the expectations of Annex 1 - particularly the emphasis on Contamination Control Strategy and risk-based design - these added complexities become liabilities rather than solutions.
Integration means the sterilising-grade filter, the test connections and the drain paths are conceived as one hydraulic system. The result is fewer joints, no stagnant zones, and a fluid path that can be reliably sterilised, drained and integrity-tested without compromise.
Why this matters for our clients
For manufacturers in Turkey preparing filling lines and biopharma processes for EU and international inspection, the difference is practical:
- Regulatory alignment: a designed-in PUPSIT approach supports a defensible Contamination Control Strategy.
- Cleanability: eliminating dead-legs reduces cleaning validation risk and microbial retention concerns.
- Lifecycle cost: fewer components mean fewer gaskets, fewer failure points and simpler maintenance.
EMA’s engineering perspective
As the authorized representative for Rattiinox aseptic valve technology, EMA Engineering works with clients not at the fitting-catalogue level but at the process-design level. We evaluate the fluid path holistically so that sterilisation, drainage and integrity testing are built in rather than bolted on. This philosophy aligns directly with the clean aseptic design principles Rattiinox has developed over decades of valve engineering.
For teams reviewing legacy lines or specifying new aseptic systems in light of Annex 1, the message is clear: stop thinking in terms of assembling components and start thinking in terms of integrating a single, validated aseptic system.


EMA Engineering supplies an integrated PUPSIT filter housing unit that brings pre-use post-sterilization integrity testing into aseptic filtration lines.
Explore EMA Engineering’s Rattiinox product range.
For product details, technical support or a quote, contact EMA Engineering via our contact page or call +90 212 798 2047.
Source: Rattiinox